shopsmith
home Frequently Asked Questions and tool tips shop tour projects contact me links build a banjo shopsmith tips miscellaneous stuff top shop tips about


Cutting the Segments for a Block Rim



I use six segments per layer when I am making a typical block rim. Each segment is 2 /12 inches wide and 7 inches long (measuring from the longest side). I find it useful to lay out my segments in advance so I can work around any defects in the wood.





I often cut the segments on my miter saw. My Delta saw doesnít have a positive stop at 30 degrees, which is a real pain in the neck.




If you donít have a miter saw, you can build a jig for your table saw. This jig holds the wood at a precise 30 degree angle as it moves through the saw.







The bottom of the jig has a hardwood runner that fits in the slot of my table saw.




This picture shows the jig in action. For photographic purposes I removed the blade guard and took the picture with the saw turned off.







Because I built this jig to fit my Shopsmith, I can swap the table saw blade for a sanding disk and sand the edge to perfection.



Back to Build a BanjoNext: Gluing Up the Rim Block



Questions or comments? Write me at
This page last updated 02/07/06
Content © 2002-2006 Song of the Great Lakes