|
Biscuit Joiner
![](pics/misc/pj1.jpg)
I used to keep the biscuit joiner bolted to my bench.
![](pics/misc/pj2.jpg)
Cutting slots for biscuits was a snap.
![](pics/misc/pj4.jpg)
I could loosen the bolts to add shims for thicker wood.
![](pics/misc/pj5.jpg)
The only drawback was that it was always out. So I took some scrap wood and made this holder...
![](pics/misc/pj6.jpg) And now all I have to do is to set the biscuit joiner assembly into the holder and I'm ready to go. A tongue on the front of the assembly drops into the slot on the holder. There are no nuts or bolts to tighten and I can set it up or take it down in about thirty seconds.
|